Multiband USB IF
Provide your IR camera with visible image.
Multiband USB IF is an upgrade of the Mini_USB IF able to make video streaming of any DPV IR sensor (up to 80MHz PCLK) and visible video streaming.
Two Serial communication port is provided to communicate with the front-end sensor or any other attached system.
Any doubts? Contact us
Multiband USB IF are designed to run over USB3.0. Besides SENSIA USB IFs systems are compatible with USB2.0. Performance using the USB2.0 interface may be decreased, performance will be sensor dependant due to USB2.0 band width.
Features
Compact and low power
USB Bus Powered
Current consumption (Sensor dependant)
USB 3.0 and USB 2.0 compatible
Visible Module Interface
MIPI compatible (FW dependant)
- Up to 80MHz parallel LVTTL/LVCMOS video inputs
- Pixel depth range (bits): Up to 16 (8, 10, 12, 14,16)
- YUV4:2:2 output format
- UART COM port and DVP in the same compound device
- 2.5 / 3.3 V video input voltage levels
- Compatible with all DPV sensors up to 80MHz PCLK.
- Tested sensors:
- SCD compatible sensors:
- VOxI
- PelicanD (SENSIA Camera Link Adapter required)
- ULIS compatible sensors:
- PICO
- SCD compatible sensors:
- UART TTL
- 2xUSB-C 3.1 ports
- 8 x External GPIO OUTPUTS (3.3V)
- Connector
- Rugged Type-C
- Operating Temperature Range
- -30ºC to 85ºC
- Size (LxWxD)
- Straight Connector: 35mm x 35mm x 21mm
- Elbow Connector:35mm x 42mm x 13mm
- Stack
- Single board
- Sensor Connector
- LSHM-140-02.5-L-DV-A-S-K
- MIPI Connector
- DF30FC-30DP-0.4V(81)
- External GPIOs / GPIOs sensor
- 5 / 8
- GPIOs Voltage Level
- 3V TTL signals
- External GPIOs Connector (FCC)
- FH12-8S-1SH (55)
- Power On Indicator Connector